OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0045

Vehicle Communication Bus B (-) Shorted to Bus B (+)

U0045 describes the two wires of Vehicle Communication Bus B touching each other. Deutz uses this code in the EMR L1 engine controller for a short circuit on its third CAN channel, without further detail. On a high-speed-type CAN, bridged wires leave no differential voltage, every bit reads recessive and, per onsemi, nothing can be transmitted while the CANH driver works into its current limit; NXP adds that transceiver diagnosis cannot see this short. On a fault-tolerant low-speed network, NXP's TJA1055 first sees a permanent dominant level, then after a time-out switches off CAN-Low and keeps going on CAN-High. Typical causes are crushed harness sections, water in splices and a damaged module input. No car maker documents U0045 publicly; near-zero ohms between the wires with the battery off confirms the fault.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 45

Possible causes

  • Harness crushed so that both bus wires touch high
  • Water in a splice or connector bridging the two wires medium
  • Damaged module input shorting its bus pins low

Symptoms

  • Every function on Bus B unavailable (high-speed type)
  • Several warning lamps on at once
  • Lost-communication codes in modules on other networks

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0045

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication