OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0043

Vehicle Communication Bus B (-) Low

U0043 reports the (-) line of Vehicle Communication Bus B shorted toward ground. Where Bus B is built like a high-speed CAN, that line is CAN-Low, and the fault is sneaky: onsemi measured frames still getting through, with distorted levels and the node drawing about 72 mA instead of 65 mA, because the CANH driver now pushes current through the termination into ground. NXP lists the case among hidden failures. NXP's fault-tolerant TJA1055 transceiver instead detects the short, switches off its CAN-Low driver and carries on single-wire over CAN-High. In both cases the vehicle tends to run normally, with the code logged by one module or showing up only now and then, which sets it apart from U0040, where the bus goes quiet. No manufacturer documents U0043 publicly; near-zero ohms from CAN-Low to ground confirms it.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 43

Possible causes

  • (-) wire insulation damaged and touching ground high
  • Harness trapped under a panel or bracket medium
  • Faulty transceiver pulling the (-) line to ground low

Symptoms

  • Vehicle mostly normal, code stored by a single module
  • Occasional communication errors

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0043

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication