U0042
Vehicle Communication Bus B (-) Open
U0042 points to an interrupted (-) wire on Vehicle Communication Bus B; on a CAN-type bus that is CAN-Low. The network then splits along the break, and on a standard high-speed CAN neither side's transceiver can tell what happened, since NXP states that line interruptions escape even transceiver diagnosis. Detection rests on time-outs for messages from nodes on the far side. On a fault-tolerant low-speed CAN, the TJA1055 data sheet from NXP treats a CAN-Low interruption as a failure that frames in progress survive. A resistance check across the two bus wires at a central connector helps: with both terminations reachable it reads about 60 ohms, a break in one wire leaves only the near terminator at about 120 ohms. No manufacturer documents U0042 publicly; start with connectors that were opened recently.
Possible causes
- (-) wire of Bus B broken in the harness high
- Corroded or pushed-back terminal in a connector medium
- Connector not reconnected after a repair medium
Symptoms
- Modules beyond the break no longer respond
- Lost-communication codes stored alongside
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0042
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.