U0041
Vehicle Communication Bus B (+) High
U0041 means the (+) wire of Vehicle Communication Bus B sits at too high a voltage, typically because it touches a battery or 5 V supply. For a high-speed-type CAN this is CAN-High, and NXP classes a short of CAN-High to battery or to VCC as a hidden failure: frames keep flowing, so only a transceiver with bus diagnosis, such as the TJA1043, reports it. On a fault-tolerant low-speed CAN NXP's TJA1055 reacts in two steps after time-outs and finally switches off its CANH driver, running on CAN-Low alone. Either way the vehicle often behaves normally, and the code may sit in memory long before anything fails. No manufacturer documents U0041 publicly. A reading near supply voltage on CAN-High against ground confirms it; check for chafing against feed wires and moisture in connectors.
Possible causes
- (+) wire chafed against a battery or 5 V feed high
- Moisture in a connector bridging the (+) wire to a supply pin medium
- Faulty transceiver driving the (+) line high low
Symptoms
- Often no noticeable symptom, code found during a scan
- Sporadic warnings from one module
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0041
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.