U0036
Vehicle Communication Bus A (-) Shorted to Bus A (+)
U0036 describes a short between the (+) and (-) wires of Vehicle Communication Bus A. On a CAN-type bus the differential voltage then stays at zero, receivers see only recessive bits and, as onsemi's measurements on high-speed CAN show, no frame can be sent any more; NXP adds that transceiver diagnosis cannot detect this short. Audi documents U003600 under exactly its J2012 name for the 2018-21 Q5 plug-in hybrid: together with U002800, U002900 and drive-motor and power-electronics codes it appears when the 12 V harness of the power electronics chafes against the underbody trim, with warning lamps and in some cases a car that cannot be driven. The fix is repairing the wires and rerouting the harness. With the battery off, near zero ohms between the bus wires confirms the short.
Possible causes
- Harness chafed so that both bus wires touch (Audi Q5 PHEV: underbody trim) high
- Water in a splice or connector bridging the two wires medium
- Damaged transceiver shorting its bus pins low
Symptoms
- Several warning lamps on at once
- Vehicle may refuse to drive (Audi Q5 PHEV)
- Drive-motor and power-electronics codes stored alongside
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0036
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.