Network
generic / SAE
U0035
Vehicle Communication Bus A (-) High
Bus A low-side line voltage above the expected range. Short to power or transceiver fault. A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 35
Possible causes
- CAN-L shorted to battery high
- Gateway module routing CAN messages incorrectly low
- CAN terminating resistor (120 Ω) drifted out of spec low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 80–1500 €
- Estimated time: 1–6 h
- Component: bus a wiring
- Component: bus a transceiver
- MIL / check engine light
- limp mode possible
Sources
References
sae:J2012