U0034
Vehicle Communication Bus A (-) Low
U0034 flags the (-) wire of Vehicle Communication Bus A pulled toward ground. On a high-speed-type CAN, the layout Audi uses for the sensor/hybrid CAN behind this slot, that wire is CAN-Low, which normally drops by about a volt for dominant bits. onsemi found that with CAN-Low grounded, frames still pass, but the bus levels are distorted and the sending node draws more current, because its high-side driver now feeds the termination against ground. NXP lists this case among the hidden failures that go unnoticed without transceiver diagnosis. Expect intermittent errors or one module reporting the code rather than a dead network. No manufacturer documents U0034 publicly. A resistance near zero between CAN-Low and ground with the battery off confirms it.
Possible causes
- (-) wire insulation damaged and touching ground high
- Harness pinched by a bracket or panel medium
- Faulty transceiver pulling the (-) line to ground low
Symptoms
- Intermittent communication errors, vehicle mostly normal
- Code reported by a single module
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0034
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.