OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0032

Vehicle Communication Bus A (+) High

U0032 reports excess voltage on the (+) line of Vehicle Communication Bus A, usually from contact with battery voltage. If Bus A is a two-wire CAN of the high-speed type, as Audi's sensor/hybrid CAN, the (+) wire is CAN-High. onsemi's bench tests show frames still getting through with CAN-High at 12 V, only with distorted levels; NXP counts such shorts among hidden bus failures that a plain transceiver does not report. Faults therefore show up as sporadic message errors or a single module complaining while the vehicle behaves normally, quite unlike the hard stop of U0031. No manufacturer documents U0032 publicly. A reading close to battery voltage on CAN-High against ground, instead of somewhere between 2.5 V and 3.5 V, confirms it; a harness rubbed through next to a supply cable or a wet connector is the usual cause.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 32

Possible causes

  • (+) wire chafed against a battery or ignition feed high
  • Water in a connector bridging the (+) wire to a supply pin medium
  • Aftermarket device connected to the bus wire low

Symptoms

  • Sporadic warnings or brief function dropouts
  • Only one module reports the fault, vehicle otherwise normal

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0032

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication