U0030
Vehicle Communication Bus A (+) Open
U0030 stands for an open circuit in the (+) wire of Vehicle Communication Bus A. What that wire is depends on the network a maker assigns to Bus A; where it is a two-wire CAN, like the sensor/hybrid CAN Audi files under this name in its 48 V mild hybrids, the (+) line is CAN-High. A break splits the bus: nodes on opposite sides lose each other, while modules sharing an intact section may still exchange frames. NXP points out that ordinary high-speed transceivers cannot recognise an interrupted wire themselves, so the module has to deduce it from missing partners or error counters. No manufacturer documents U0030 publicly; CARB only requires missing communication from digital inputs to be detected and coded separately. Check terminals, splices and the resistance between (+) and (-).
Possible causes
- (+) wire of Bus A broken in the harness high
- Terminal backed out or spread in a connector medium
- Connector left unplugged after a repair medium
Symptoms
- Functions served by modules beyond the break stop working
- Lost-communication codes for some modules on Bus A
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0030
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.