OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0026

Low Speed CAN Communication Bus (-) High

U0026 means CAN-Low, the (-) line of a two-wire low-speed CAN, is held too high. Since this wire already sits near 5 V at rest in an ISO 11898-3 network, the outcome depends on where the short goes. Against the 5 V supply (failure 6a in NXP's TJA1055) the transceiver stays in differential mode with normal drivers and termination. Against battery voltage (failure 6) its comparator trips after roughly 0.3 to 1.6 ms, the CAN-Low driver is switched off, the termination becomes a weak pull-up and reception continues over CAN-High alone. Either way the bus normally survives, which is why the code is often found without a clear complaint. No manufacturer documents U0026 publicly, and the GM low-speed GMLAN gets by with one conductor. Look for chafing against a feed wire or water in a connector.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 26

Possible causes

  • CAN-Low chafed against a battery or ignition feed high
  • Moisture in a connector linking CAN-Low to a supply pin medium
  • Faulty transceiver driving CAN-Low to its supply low

Symptoms

  • Often no noticeable effect
  • Occasional comfort function dropouts when the bus runs on one wire

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0026

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication