U0025
Low Speed CAN Communication Bus (-) Low
U0025 flags CAN-Low pulled toward ground on a low-speed CAN with two conductors. In the fault-tolerant physical layer of ISO 11898-3 CAN-Low idles near 5 V, so a ground short forces it into its dominant state for good. NXP's TJA1055 (failure 4) first sees a permanently dominant receive signal; after about 0.3 to 1.6 ms it switches the CAN-Low driver off, changes that line's termination to a weak pull-up and continues in single-wire mode on CAN-High. Messages keep flowing, but with weaker immunity to interference, so sporadic dropouts of comfort functions are possible. The transceiver goes back to differential mode by itself once the short is gone. No manufacturer documents U0025 publicly; GM's one-conductor bus has no (-) side at all. Resistance from CAN-Low to ground near 0 Ω with the battery off confirms the fault.
Possible causes
- CAN-Low insulation damaged and touching body ground high
- Harness trapped by a panel, bracket or seat mechanism medium
- Module transceiver internally shorting CAN-Low to ground low
Symptoms
- Comfort functions work but drop out now and then
- Body modules store the code repeatedly
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0025
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.