OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0018

Medium Speed CAN Communication Bus (-) Shorted to Bus (+)

U0018 describes the two medium-speed CAN lines, CAN-Low and CAN-High, shorted together. With no voltage difference left, receivers see only recessive bits, nobody can win arbitration, and the controllers on the segment eventually go bus-off; onsemi's measurements on the comparable high-speed layer show transmission stopping completely. NXP notes that transceiver diagnosis does not catch this short, so it is inferred from protocol errors. No manufacturer documents U0018 publicly. Expect the complete comfort network to fail together while the powertrain bus stays unaffected. With the battery disconnected, a near-zero resistance between (+) and (-) in place of the normal termination value confirms it; separating connectors section by section narrows the location, often a crushed or wet harness.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 18

Possible causes

  • Medium-speed bus pair crushed so both wires touch high
  • Water in a connector bridging (+) and (-) medium
  • Failed transceiver shorting both bus pins in a comfort module low

Symptoms

  • Entire comfort network fails, powertrain unaffected
  • Body modules unreachable with the scan tool

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0018

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication