U0013
Medium Speed CAN Communication Bus (+) Low
U0013 indicates that CAN-High on the medium-speed bus, the (+) wire, is pulled toward ground. Where this network uses the same differential layout as high-speed CAN, as Saab's terminated mid-speed GMLAN suggests, a grounded CAN-High rules out any dominant bit; onsemi and NXP list this short among those that end all communication. Every node on the segment, usually body, climate and infotainment units, therefore goes quiet together, and the gateway or body controller stores missing-message codes for them. No manufacturer documents U0013 publicly. Powertrain functions on the separate fast bus normally carry on. With the battery off, a resistance of only a few ohms from CAN-High to ground locates the short; typical spots are door boots, seat rails and trim fasteners.
Possible causes
- Medium-speed CAN-High insulation damaged against body ground high
- Wires broken open in a door boot or tailgate grommet medium
- Comfort module transceiver pulling CAN-High down low
Symptoms
- All comfort and infotainment modules fail together
- Engine and transmission keep working normally
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0013
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.