OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0008

High Speed CAN Communication Bus (-) High

U0008 means CAN-Low, the (-) wire of the high-speed CAN, is forced too high, typically through contact with the 12 V system or another supply rail. This fault blocks the bus: CAN-Low can no longer be driven down, no dominant state develops, and both onsemi and NXP found that transmission becomes impossible. Senders accumulate errors until they reach bus-off, so U0001 and lost-communication codes nearly always appear alongside, and engine, transmission or brake electronics may switch to stored default values. No manufacturer documents U0008 publicly. With ignition on, CAN-Low reading close to battery voltage instead of about 1.5 to 2.5 V confirms it; the contact point is usually where the bus pair runs beside a supply feed, for example after an accessory installation.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 08

Possible causes

  • CAN-Low chafed against a battery or ignition supply wire high
  • Retrofit wiring tapped into the bus pair by mistake medium
  • Bent pin or moisture linking CAN-Low to a supply contact low

Symptoms

  • Total communication loss on the high-speed network
  • Many warning lamps, possible no-start
  • Scan tool cannot reach powertrain modules

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0008

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication