U0007
High Speed CAN Communication Bus (-) Low
U0007 reports that the (-) line CAN-Low on the fast bus is held below its valid band, normally by a short to ground. The physical layer copes with this particular case: onsemi recorded ongoing transmission with a distorted level pattern and raised transceiver current, and NXP counts it among the hidden failures. Traffic therefore continues, yet the reserve against interference shrinks, which may surface as an occasional lost frame or a brief warning. Only modules whose transceiver offers bus diagnosis can spot the condition directly. No manufacturer documents U0007 publicly; FCA field cases describe ground shorts on the CAN C (+) and (-) lines under U0001. Inspect sections near sheet-metal edges, brackets and seat rails, then measure CAN-Low to ground with the battery disconnected.
Possible causes
- CAN-Low insulation worn through against body metal high
- Water in a connector bridging CAN-Low to a ground pin medium
- Module transceiver internally shorted on its CAN-Low pin low
Symptoms
- Usually no noticeable malfunction, code found during a scan
- Occasional short-lived warnings, worse with moisture
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0007
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.