U0006
High Speed CAN Communication Bus (-) Open
U0006 points to an interrupted CAN-Low conductor, i.e. the (-) line on the high-speed network. That line rests near 2.5 V and sinks by about a volt whenever a dominant bit is sent. Nodes isolated by the break no longer receive a usable differential signal from the rest of the network, while the modules still joined on both wires can go on exchanging data. A line interruption is outside what common high-speed transceivers can diagnose themselves (NXP), so the code relies on module-specific checks such as missing acknowledgements. No manufacturer documents U0006 publicly. Frequent findings are a conductor fractured at a door or tailgate hinge, a backed-out terminal or a corroded splice. With the battery disconnected, a check across the two lines often shows about twice the normal 60 ohms when the break separates one of the terminators.
Possible causes
- CAN-Low conductor fractured at a hinge or flex point high
- Corroded splice or connector in the CAN-Low path medium
- CAN-Low terminal backed out after work on the harness medium
Symptoms
- Part of the modules unreachable, others still respond
- Warnings from the affected systems, sometimes only when moving doors or harness
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0006
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.