OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0005

High Speed CAN Communication Bus (+) High

U0005 flags CAN-High, the (+) wire of the high-speed bus, sitting above its permitted range, generally because it touches battery voltage or a 5 V feed. Unlike a ground short this does not have to halt traffic: onsemi and NXP both found that frames still pass, but the voltage picture is distorted, noise immunity worsens and, on networks with a large capacitive load, bit timing can be violated. NXP therefore classes it as a hidden bus failure that only transceivers with diagnosis can see. The usual result is occasional message loss, intermittent warnings, or a single module that reports the fault while the car drives normally. No manufacturer documents U0005 publicly. Measuring CAN-High against ground with ignition on shows a value near supply voltage instead of about 2.5 to 3.5 V.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 05

Possible causes

  • CAN-High chafed through against a battery or ignition feed high
  • Moisture bridging CAN-High to a supply pin in a connector medium
  • Incorrectly connected accessory or retrofit module low

Symptoms

  • Sporadic warnings, often with no lasting malfunction
  • Individual messages or modules dropping out under load or in damp weather

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0005

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication