OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P34C8

Camshaft Position Control Module Performance

P34C8 does not point at one actuator or bank; it says the separate controller for cam adjustment is not working properly in itself. Mitsubishi defines it for the 2022 Outlander: with the ignition on, the controller of the electric intake phaser detects an internal CPU error, and the module is the only listed cause. Fail-safe then parks the electric intake motor and the exhaust oil control solenoid at their reference angle, lets the runner flap open, stops EGR, drops stratified cold starts and runs idle at a set speed. Mercedes-Benz lists P34C800 for M176/M177 V8s as a general CAMTRONIC fault (LI05.20-P-080192), with a software update, newer actuators and a check for heat-damaged harness as remedy. Unlike P34C4 to P34C7, which judge one output stage, this code concerns the module as a whole.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / C8

Possible causes

  • Internal processor fault in the cam adjustment control module high
  • Outdated control software (Mercedes M176/M177: update) medium
  • Module supply or harness heat-damaged or with poor contact low

Symptoms

  • Check engine light on
  • Cam phasing held at its reference position
  • Rougher cold start and fixed idle speed
  • Noticeably less torque, higher fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P34C8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication