OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P34C7

B Camshaft Position Actuator Control Circuit Driver Current/Temperature Too High Bank 2

P34C7 closes the group of four driver-load codes: on bank 2 the power stage of the exhaust-side actuator B reports current or temperature above its limit. NTN-SNR ties it to outlet adjustment on the second bank. It is the rarest of the set, because electric phasers have so far appeared on the intake side; no public manufacturer document names P34C7. The fault type means the module is guarding itself, not that a sensor reads wrong, since position and temperature sensor faults of this actuator have their own codes (P34C0 to P34C3, P34B8). Plausible triggers are a motor working against a seized or poorly oiled phaser, a short in its wiring, or a driver that runs hot because it sits close to the exhaust side. CARB treats such phasers as monitored outputs. Driving continues, just with exhaust timing locked. Bank 1: P34C6.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / C7

Possible causes

  • Bank 2 exhaust phaser seized or poorly lubricated medium
  • Motor wiring of actuator B, bank 2, shorted or heat-damaged medium
  • Driver overheating from poor cooling or a module fault low

Symptoms

  • Check engine light on
  • Bank 2 exhaust timing no longer varied
  • Usually only small changes in how the engine runs

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P34C7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication