P34C6
B Camshaft Position Actuator Control Circuit Driver Current/Temperature Too High Bank 1
P34C6 concerns actuator B, which NTN-SNR assigns to the exhaust camshaft, on bank 1: the stage driving it signals overcurrent or overheating. That presumes an electrically powered exhaust phaser, and none is documented in public sources. The 2022 Mitsubishi Outlander shifts its exhaust camshaft hydraulically via a solenoid valve, which fail-safe holds at a reference angle, and Mercedes-Benz uses B-side codes on its M176/M177 V8 only for CAMTRONIC position feedback, not for driver load. So no manufacturer is known for this code. Should it appear, the logic of the Aisin patent applies: a hot driver board or a motor fighting a stiff phaser pushes current up, and the controller backs off or switches the motor off. Exhaust timing then rests at its default, which mainly costs smoothness and some economy. Bank 2: P34C7.
Possible causes
- Exhaust phaser on bank 1 stiff, motor overloaded medium
- Short in the motor wiring of actuator B, bank 1 medium
- Output stage for actuator B damaged or overheated low
Symptoms
- Check engine light on
- Exhaust cam timing on bank 1 fixed in its default position
- Slightly higher fuel use, minor loss of smoothness
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P34C6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.