P34C5
A Camshaft Position Actuator Control Circuit Driver Current/Temperature Too High Bank 2
P34C5 mirrors P34C4 on bank 2 for intake actuator A: the driver powering the electric phaser motor on the second cylinder bank has measured too much current or run too hot and protects itself. Only V or boxer engines with one electric intake phaser per bank can log it. Two banks give a handy cross-check: if the fault stays on bank 2 after the motors trade places, wiring or the module are to blame; if it moves with the motor, the motor is. The Aisin patent explains why heat and current are judged together, as pressing the phaser hard against its stop lifts both at once. NTN-SNR places it on the bank 2 inlet side. No carmaker publishes P34C5; Nissan's module bulletin NTB18-016 for the 2018 Pathfinder only shows the hardware type. Bank 1: P34C4.
Possible causes
- Bank 2 phaser stiff or stuck at an end stop high
- Motor lead to the bank 2 actuator chafed or shorted medium
- Electric motor of the bank 2 actuator worn or internally shorted medium
- Bank 2 output stage in the phaser control module faulty low
Symptoms
- Check engine light on
- Bank 2 intake timing frozen, banks run unevenly
- Slightly rough idle and less torque at low engine speed
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P34C5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.