OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P34C1

B Camshaft Position Actuator Position Sensor A Range/Performance Bank 2

Mercedes-Benz names P34C109 for the exhaust side of bank 2 on its CAMTRONIC V8s: the signal from the sensor at solenoid 1 is wrong although the circuit is intact, entered as a component fault. CARB explains why such a check exists, since even a single cylinder pin on a lift mechanism not moving into place is a failure mode that VVT monitoring has to cover. The same bulletin, LI05.20-P-080192, also carries P005C (solenoid 1, exhaust, bank 2: faulty or jammed off) and P164B (CAMTRONIC limp-home). The Mercedes remedy: engine software, current actuator part numbers, and a look at the harness for heat damage. Because the solenoid sensor is integrated, a confirmed fault calls for replacing the actuator. Bank 1 counterpart: P34BD.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / C1

Possible causes

  • CAMTRONIC actuator of an older part number (Mercedes: replace) high
  • Engine control software needs an update high
  • Actuator pin sticking or moving too slowly medium

Symptoms

  • Check engine light on
  • CAMTRONIC limp-home, often together with P005C

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P34C1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication