P34BE
B Camshaft Position Actuator Position Sensor A Circuit Low Bank 1
For P34BE, too, a Mercedes-Benz text exists: the CAMTRONIC bulletin covering the M176 and M177 eight-cylinders reads P34BE00 as the signal of exhaust solenoid 1, bank 1, being grounded. That fits the generic meaning, a signal under its lower limit. Mercedes points to the engine cover and the wiring routed over the bulkhead, close to the windshield, where heat damage was found; harness damage is to be reported with photos and a lambda graph test. Beyond the wiring, the remedy includes fitting the latest CAMTRONIC actuators and updating the engine software. Once the feedback is lost the system can enter limp-home (P164B), and the exhaust cam profile of that bank stays fixed. High on bank 1: P34BF; low on bank 2: P34C2.
Possible causes
- Heat-damaged harness above the bulkhead, signal shorted to ground high
- Sensor inside the CAMTRONIC actuator shorted (older part number) medium
- Engine control software not up to date low
Symptoms
- Check engine light on
- CAMTRONIC limp-home, exhaust valve lift on bank 1 no longer switched
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P34BE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.