P34B3
A Camshaft Position Actuator Position Sensor A Circuit High Bank 2
P34B3 marks a signal above the upper limit from position sensor A on the intake phaser of bank 2. An interrupted ground, a signal wire touching a supply voltage or a worn-out sensor are the usual findings. No carmaker publishes the code. The nearest documented case is Mitsubishi's bank 1 code P34AF on the 2022 Outlander: the high value must persist for at least a second, and the Hall sensor of the actuator motor is listed as a possible cause. With an electric phaser the sensor therefore sits inside the actuator, and a sensor fault usually means replacing the actuator. NTN-SNR lists P34B3 as the inlet-side position sensor A on the second bank with too high a signal. The engine keeps running with the bank 2 phaser at its base angle.
Possible causes
- Sensor ground interrupted high
- Signal wire touching a supply voltage medium
- Hall sensor in the actuator defective (actuator replacement) medium
Symptoms
- Check engine light on
- Bank 2 intake phaser held at its base angle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P34B3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.