P34AF
A Camshaft Position Actuator Position Sensor A Circuit High Bank 1
P34AF is logged when position sensor A on the bank 1 intake phaser reports a voltage above its upper limit for at least one second. Mitsubishi covers the code in its 2022 Outlander manual and, besides the harness, points to the Hall sensor of motor 1 in the electric actuator – a hint that position sensor A is a Hall element inside the phaser motor. A broken ground lead of the sensor, a signal line in contact with supply voltage or a dead Hall sensor are the usual causes; since the sensor is built into the actuator, a sensor fault normally means a new actuator. Fail-safe parks the intake phaser at its base angle, opens the intake runner valve and switches off exhaust gas recirculation. Low is P34AE, bank 2 P34B3.
Possible causes
- Sensor ground open or plug corroded high
- Signal wire shorted to supply voltage medium
- Hall sensor of the actuator motor failed (actuator replacement) medium
Symptoms
- Check engine light on
- Intake phaser held in its base position, reduced power
- Slightly higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P34AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.