P34AD
A Camshaft Position Actuator Position Sensor A Range/Performance Bank 1
P34AD covers a plausibility fault: the position sensor A signal from the intake actuator on bank 1 is electrically present but does not agree with what else the module knows. On the 2022 Mitsubishi Outlander, which turns its intake phaser electrically, the control module checks the motor position against the phase seen by the intake camshaft sensor and logs P34AD when the two disagree; wiring faults and the actuator are given as causes. In practice a worn or slipping actuator, a position that was not relearned after repairs or a disturbed cam signal come first; Nissan, which uses the same kind of electric intake valve timing, requires a position learning run after module replacement. The phaser then stays at its base angle.
Possible causes
- Electric actuator worn, sticking or slipping high
- Actuator position not relearned after repair medium
- Intake camshaft sensor signal or timing drive disturbed medium
- Intermittent wiring fault low
Symptoms
- Check engine light on
- Intake cam timing fixed, weaker response at low revs
- Possibly accompanying timing codes such as P0011
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P34AD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.