P34AC
A Camshaft Position Actuator Position Sensor A Circuit Bank 1
P34AC covers any electrical fault in the circuit of position sensor A of the intake cam actuator on bank 1. On engines with an electric intake phaser this sensor tells the controller where the drive motor stands. Mitsubishi has the code in its 2022 Outlander manual: the electric intake valve timing module logs it when the sensor voltage is too low or too high for one second or longer, and names wiring with an open or short as well as the actuator itself. In fail-safe the phaser is parked at its base angle, the intake runner valve opens, EGR stops and the cold-start stratified mode is dropped. The check runs once the engine has been above 2,000 rpm for a second and first appears as a pending code. Low and high are P34AE and P34AF.
Possible causes
- Actuator harness open or shorted, plug loose high
- Position sensor in the electric actuator failed (actuator replacement) medium
- Electric valve timing control module faulty low
Symptoms
- Check engine light on
- Intake cam held in its base position, less torque at low revs
- Rougher cold start, slightly higher consumption
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P34AC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.