P34AB
A Camshaft Position Actuator Temperature Sensor Circuit High Bank 2
P34AB stands for a voltage above the upper limit at the temperature sensor of intake cam actuator A, bank 2. An interrupted signal or ground line is the classic cause, as is a short to a higher voltage; a plug pushed off during a service visit often explains it. Because the actuator motor warms up under load, the controller depends on this value – the Aisin patent lowers the current step by step while a high temperature persists – and without it the bank 2 phaser is usually held back. NTN-SNR names the code for the inlet side of the second bank; no carmaker publishes it. The bank 1 equivalent is P34A7, the low code P34AA.
Possible causes
- Plug at the actuator off or not latched after service high
- Signal or ground wire interrupted medium
- Signal shorted to a higher voltage low
Symptoms
- Check engine light on
- Intake phasing on bank 2 held back
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P34AB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.