P34AA
A Camshaft Position Actuator Temperature Sensor Circuit Low Bank 2
P34AA reports that the temperature sensor of the bank 2 intake cam actuator signals a voltage below its permitted range. Whether that equals a hot reading depends on the sensor design, which no public source names; with the common NTC thermistor it would mimic overheating, and the controller could limit the actuator current or stop phasing on that bank. In practice a signal wire grounded against the cylinder head, cables pinched during earlier engine work or a shorted sensor are the usual suspects. NTN-SNR lists P34AA as too small a signal of the inlet temperature sensor on the second bank; a manufacturer text is not public. Compare bank 1 (P34A6) and the high code P34AB.
Possible causes
- Signal wire grounded against the cylinder head high
- Cables pinched during earlier engine work medium
- Sensor shorted internally medium
Symptoms
- Check engine light on
- Intake phasing on bank 2 suspended, slightly less power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P34AA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.