P34A7
A Camshaft Position Actuator Temperature Sensor Circuit High Bank 1
P34A7 is set when the temperature sensor of intake camshaft actuator A on bank 1 delivers a voltage above its upper limit. Most often the sensor wire or its ground is interrupted, or the signal touches a supply voltage; with an NTC-type sensor this reads as an implausibly cold actuator. The module then lacks a usable value for its thermal protection and usually switches to a cautious phasing strategy. NTN-SNR assigns P34A7 to the inlet camshaft adjustment with too high a signal. Nissan fits such sensors to the electric intake phaser of the 2018 Pathfinder and QX60 but has not published this particular code. Check the actuator plug and the harness routing over the engine first. Low is P34A6.
Possible causes
- Signal or ground wire of the sensor interrupted high
- Signal wire shorted to a supply voltage medium
- Sensor open internally medium
Symptoms
- Check engine light on
- Intake phasing on bank 1 reduced
- Mostly no noticeable effect while driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P34A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.