P34A6
A Camshaft Position Actuator Temperature Sensor Circuit Low Bank 1
With P34A6 the temperature signal from the intake cam actuator on bank 1 sits under its minimum. No source available to us names the sensor type. If it is the usual NTC thermistor, low voltage corresponds to high temperature, so a signal line shorted to ground or an internally shorted sensor looks to the module like an overheated actuator. Electric phasers guard their motor and driver against heat – Aisin describes cutting the current in stages while the board temperature stays high – so a false hot value can make the controller hold the phaser back. NTN-SNR names P34A6 as a too-small signal of the inlet temperature sensor. No carmaker publishes this code in detail. High is P34A7, bank 2 P34AA.
Possible causes
- Signal wire shorted to ground (chafed at the cylinder head) high
- Sensor shorted internally medium
- Actuator really overheated by a sluggish phaser low
Symptoms
- Check engine light on
- Intake phasing on bank 1 limited, less pulling power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P34A6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.