P34A3
Cylinder 12 Deactivation/Intake Valve Performance
P34A3 closes the series at the twelfth cylinder: cylinder 12 was commanded to deactivate, but its valves did not stop. No manufacturer documents this code publicly. A dedicated check is needed because CARB's misfire definition excludes cylinders that are deliberately shut off, so the misfire monitor will not flag a skipped cylinder that still pumps air without fuel. Delphi's patent US7314034B1 confirms the state of each cylinder from the pattern of intake or exhaust pressure pulses, close to the principle GM applies to cylinders 1 to 8. On V12s that switch bank by bank, a defect would first show as rough running and a warning lamp. P3490 handles the control side of cylinder 12.
Possible causes
- Lifter or rocker switching element of cylinder 12 stuck high
- Oil control valve of the deactivation sticking medium
- Low or aged oil medium
Symptoms
- Check engine lamp on
- Rough running at light load
- Higher fuel use
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P34A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.