P349A
Cylinder 3 Deactivation/Intake Valve Performance
P349A states that cylinder 3 kept its valves working while the engine computer had switched it off. GM picks this up on its L84 and L87 V8s through manifold pressure that stays too high during the skipped strokes, Type B after 22 failed checks out of 25. Not every stored P349A means a worn lifter. For the 2021 Tahoe, Suburban, Yukon and Escalade, GM explains (PIP5731, later bulletin 20-NA-204) that a voltage dip while cranking could make the ECM drop the deactivation outputs for one trip and log this code in history without a real defect; the cure is new ECM software and a road test with a warm engine at 30 to 45 mph. If it returns, the lifters and the solenoid of cylinder 3 need checking. P3418 covers the control side.
Possible causes
- Voltage dip at cranking disabled the outputs, ECM software outdated medium
- Deactivation lifter of cylinder 3 does not unlock medium
- Lifter oil solenoid of cylinder 3 sticking medium
- Low or aged oil slowing the switching low
Symptoms
- Code stored in history with no noticeable concern
- Check engine lamp on if the fault is real
- Ticking noise or higher fuel use
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P349A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.