P3488
Cylinder 11 Exhaust Valve Control Circuit High
With P3488, the cylinder 11 exhaust actuator line sits too high, most often since the wire has picked up battery voltage. No manufacturer documents this code publicly; cylinders 9 to 12 only exist on engines with nine or more, and J2012 keeps these codes for them. Later V12 and W12 designs give it no job: Bentley's W12 idles a bank of six with its valves still moving, while the Aventador from Lamborghini parks one bank under 135 km/h. Only Mercedes' V12 of around 2000 uncoupled exhaust valves, using two solenoids for that bank. GM's comparable V8 check calls a circuit high below 0.5 ohm to supply while the driver is on, 20 of 25 samples, Type B. The actuator then cannot be engaged, and the engine just runs on all cylinders. P3487 is the ground fault.
Possible causes
- Control wire of the cylinder 11 actuator touching a battery feed high
- Shorted turns in the actuator coil medium
- Output stage in the engine control module failed low
Symptoms
- Check engine lamp on
- Engine stays on all twelve cylinders
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3488
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.