P3484
Cylinder 11 Deactivation/Intake Valve Control Circuit High
P3484 signals that the control circuit of the cylinder 11 deactivation or intake valve actuator is too high, for example because its wire is shorted to a battery feed and the module detects it when switching the output on. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. Twelve-cylinder engines that shut down cylinders, notably the Bentley W12 in Bentayga and Continental GT and the Lamborghini Aventador V12, describe their systems as switching off a whole bank, with Bentley stating that the valves keep moving. P3484 thus fits only a design with a dedicated valve actuator at cylinder 11. The control module will normally cancel deactivation and run on all cylinders. P3481 and P3483 are the remaining electrical faults.
Possible causes
- Cylinder 11 control wire touching battery voltage high
- Cylinder 11 actuator coil with shorted turns medium
- Control module driver damaged low
Symptoms
- Check engine lamp on
- Reduced-cylinder mode cancelled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3484
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.