OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3476

Cylinder 10 Deactivation/Intake Valve Control Circuit High

P3476 is logged when the control circuit of the cylinder 10 deactivation or intake valve actuator sits at too high a level, usually a short to a battery-fed wire found while the output is active. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. On the V10s that offer shut-off, Audi describes the bank being stopped by cutting fuel injection and ignition in the upper gears, so cylinder 10 has no valve actuator there. A twelve-cylinder engine with valve switching, such as Mercedes' M137 with its oil-pressure solenoid pack, is the kind of design this code was written for. The control module then usually blocks deactivation for the rest of the trip. Electrical siblings: P3473 and P3475.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 76

Possible causes

  • Cylinder 10 control wire shorted to a supply high
  • Cylinder 10 actuator coil with shorted turns medium
  • Control module output stage defective low

Symptoms

  • Check engine lamp on
  • Cylinder deactivation locked out for the drive

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3476

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication