OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3475

Cylinder 10 Deactivation/Intake Valve Control Circuit Low

P3475 points to a short to ground on the circuit that controls deactivation or the intake valve of cylinder 10. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. The Lamborghini Huracán's V10 runs on five cylinders at light load and the Aventador V12 on six below 135 km/h, yet neither maker publishes code-level diagnostics, and Audi's sister V10 manages without valve actuators. For a sense of the test, GM's eight-cylinder version of the low check needs below 0.5 ohm to ground while the output is off, sampled every 250 ms. Check the wire to cylinder 10 for chafing first, then the actuator itself. P3473 handles an open line, P3476 a short to voltage, P3479 the exhaust counterpart.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 75

Possible causes

  • Cylinder 10 control wire grounded through chafing high
  • Actuator of cylinder 10 shorted internally medium
  • Water in the actuator connector low
  • Defective control module output stage low

Symptoms

  • Check engine lamp on
  • Reduced-cylinder mode unavailable
  • Possible misfire on cylinder 10

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3475

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication