OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3468

Cylinder 9 Deactivation/Intake Valve Control Circuit High

P3468 indicates that the control circuit for the cylinder 9 deactivation or intake valve actuator is pulled high, typically by a short to battery voltage that the module notices once it switches the output on. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. Most engines above eight cylinders that shut cylinders down, such as Audi's R8 V10 and Bentley's W12, do so bank by bank without dedicated valve actuators; Mercedes' M137 V12, by contrast, used a solenoid pack. GM's eight-cylinder version of this check counts below 0.5 ohm to controller power with the driver on, 20 of 25 samples. Expect the module to shut the output off and run all cylinders. P3465 (open) and P3467 (ground short) are the other electrical faults here.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 68

Possible causes

  • Cylinder 9 control wire touching a supply wire high
  • Shorted turns in the cylinder 9 solenoid coil medium
  • Output stage of the engine control module damaged low

Symptoms

  • Check engine lamp on
  • Engine runs on all cylinders at all times

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3468

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication