OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3467

Cylinder 9 Deactivation/Intake Valve Control Circuit Low

With P3467 the control line of the cylinder 9 deactivation or intake valve actuator reads too low, which usually means it is touching ground. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. Twelve-cylinder engines with cylinder shut-off do exist, for instance Mercedes' M137 and Lamborghini's Aventador V12 introduced in 2012, but no published diagnostic list connects this number to them. GM's matching test on its V8 engines looks for less than 0.5 ohm to ground with the driver switched off and only runs above 11 V and 425 rpm. On a low-side driven solenoid, a ground fault can keep the coil energised, so the cylinder may drop out when it should fire. Siblings: P3465 open circuit, P3468 short to voltage.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 67

Possible causes

  • Cylinder 9 control wire shorted to ground high
  • Internal short in the cylinder 9 solenoid medium
  • Moisture in the solenoid connector low
  • Faulty driver in the engine control module low

Symptoms

  • Check engine lamp on
  • Cylinder deactivation disabled
  • Possible misfire on cylinder 9 if the actuator stays energised

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3467

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication