P3466
Cylinder 9 Deactivation/Intake Valve Control Performance
P3466 is the plausibility test for cylinder 9: its actuator circuit is electrically sound, yet the cylinder fails to change state when the engine computer commands it. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. In valve-based systems the switching happens hydraulically; NHTSA's account of GM's design describes oil pressure moving locking pins inside the lifter. The Mercedes M137 V12, whose shut-off system relied on a solenoid pack and oil pressure tubes, is known for trouble with exactly those parts, exactly the kind of fault this code targets. Bank-switching V10 and W12 engines from Audi and Bentley leave the valves running and have nothing comparable to check. P3465, P3467 and P3468 are the electrical faults of cylinder 9.
Possible causes
- Oil level, pressure or quality too poor to switch cylinder 9 high
- Leak at the oil tubes or solenoid pack feeding cylinder 9 medium
- Switching lifter of cylinder 9 sticking medium
- Solenoid valve slow or sticking mechanically low
Symptoms
- Check engine lamp on
- Misfire count on cylinder 9 (P0309)
- Rough running while switching between full and partial mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P3466
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.