OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3465

Cylinder 9 Deactivation/Intake Valve Control Circuit/Open

P3465 flags an open circuit to the actuator meant to shut down cylinder 9 or hold its intake valve closed. No manufacturer documents this code publicly; J2012 reserves the codes for cylinders 9 to 12 for engines with more than eight cylinders. Among such engines, Mercedes' M137 V12 (S 600 and CL 600, 1998 to 2002) had a shut-off system built around a solenoid pack and oil pressure tubes, whereas Audi's R8 V10 idles a whole bank by stopping injection and ignition. For orientation, GM treats the comparable circuit on its V8s as open above 200 kohm with the driver off, 20 failures in 25 samples. P3467 and P3468 cover shorts on the same line, P3466 a mechanical fault, P3469 the exhaust side of cylinder 9.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 65

Possible causes

  • Broken or chafed wire to the cylinder 9 actuator high
  • Open coil in the cylinder 9 solenoid medium
  • Loose or corroded connector at the solenoid pack medium
  • Output stage in the engine control module failed low

Symptoms

  • Check engine lamp on
  • Cylinder shut-off no longer engages
  • Slightly higher fuel consumption at part load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3465

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication