P3464
Cylinder 8 Exhaust Valve Control Circuit High
P3464 is stored once the line to a stand-alone cylinder 8 exhaust actuator sits at a high level, typically a wire touching battery voltage. No manufacturer documents this code publicly. According to GM bulletin 20-NA-038, cylinder 8 is switched off only by DFM engines and by the LTA and LT2, whose fixed pattern is 2, 3, 5 and 8; classic AFM uses 1, 7, 6 and 4. On those engines a single solenoid also moves the exhaust lifter, and GM lists a short to power on it as P3460: with the low-side driver commanded on, less than 0.5 ohm to supply, 20 of 25 samples, Type B. Its malfunction text says cylinder 7, a copy slip in the 2019 table. The shorted output cannot pull in, so cylinder 8 simply stays active. P3463 is the ground fault.
Possible causes
- Control wire of the cylinder 8 actuator touching a battery feed medium
- Shorted turns in the actuator coil, resistance far too low medium
- Output stage in the engine control module failed low
Symptoms
- Check engine lamp on
- Engine keeps running on all eight cylinders, slightly higher fuel use
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3464
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.