P3460
Cylinder 8 Deactivation/Intake Valve Control Circuit High
P3460 reports a short to supply voltage on the control circuit of the cylinder 8 deactivation solenoid, found while the output is switched on. GM lists it for the 2019 L84: under 0.5 ohm between output and controller power, 20 of 25 samples spaced 250 ms apart, Type B, with the same 11 V and 425 rpm enable limits as the other cylinder 8 circuit checks. GM's table contains a slip here: the strategy column for P3460 speaks of the cylinder 7 solenoid, while code and component name cylinder 8. Typical causes are harness damage against a feed wire or a solenoid with shorted turns; the visible result is that the engine stops using cylinder 8 deactivation. Siblings: P3457 (open) and P3459 (short to ground).
Possible causes
- Cylinder 8 control wire in contact with a voltage source high
- Shorted turns in the cylinder 8 solenoid medium
- Faulty driver in the engine control module low
Symptoms
- Check engine lamp on
- Cylinder deactivation inactive, slightly higher fuel use
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3460
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.