OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3458

Cylinder 8 Deactivation/Intake Valve Control Performance

P3458 describes a cylinder 8 that does not deactivate or reactivate as commanded although its control circuit is electrically fine. No manufacturer documents this code publicly. GM, the only maker with published cylinder 8 deactivation codes, files this failure under P349F on the L84: during a commanded skip, filtered manifold pressure stays above a threshold, which means the intake and exhaust valves kept working; the test runs with air charge above 120 mg and MAP/BARO between 0.30 and 0.95, and 22 failures in 25 opportunities give a Type B code. Bulletin 20-NA-204 adds that on 2021 full-size SUVs with L84 and L87 a voltage dip during cranking can set P349F without any hardware fault. Electrical faults are P3457, P3459 and P3460.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 58

Possible causes

  • Cylinder 8 deactivation lifter not unlocking or relocking medium
  • Oil pressure too low or oil aerated medium
  • Cylinder 8 solenoid valve sluggish or its screen blocked medium
  • False entry after low voltage while cranking, fixed by ECM update (GM analogue 20-NA-204) low

Symptoms

  • Check engine lamp on, sometimes going out again
  • Shake or roughness in light-load cruising
  • Misfire on cylinder 8 (P0308)

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P3458

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication