OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3455

Cylinder 7 Exhaust Valve Control Circuit Low

P3455 points to a ground fault on the line that would drive an exhaust-only actuator on cylinder 7. No manufacturer documents this code publicly. On GM V8 engines, AFM and DFM alike, a single lifter oil solenoid serves intake and exhaust of each cylinder, so a grounded line there sets the intake-side code P3451: the low-side driver is switched off, the output reads under 0.5 ohm to ground, and 20 of 25 checks taken every 250 ms must fail (Type B). On FCA's Hemi, MDS wiring rubbed through by the heat shield behind the driver-side head, next to cylinder 7, shows up as P3449. With its control line grounded, the actuator could switch on uncommanded, so the cylinder may lose its valve motion while fuel still flows. P3453 is the open, P3456 the short to power.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 55

Possible causes

  • Actuator wire chafed through against the cylinder head or a heat shield high
  • Actuator coil shorted to its housing medium
  • Output stage in the engine control module damaged low

Symptoms

  • Check engine lamp on
  • Cylinder deactivation locked out
  • Rough running or misfire on cylinder 7 if the actuator pulls in unbidden

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3455

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication