OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3452

Cylinder 7 Deactivation/Intake Valve Control Circuit High

Unlike the open and ground-short checks, GM can only detect P3452 while the cylinder 7 solenoid driver is switched on, because a short to supply voltage shows up as an output that will not pull low when it should. The 2019 tables for the L84, L86 and LT4 set the limit at 0.5 ohm to controller power and need 20 errors out of 25 samples, Type B. The check therefore depends on the ECM actually commanding deactivation; on GM's DFM engines that only happens with coolant above 40 °C, more than 20 s after start and above 13 km/h, according to NHTSA. Typical causes are a harness pressed against a feed wire or a solenoid with shorted windings. P3449 and P3451 are the other circuit codes for cylinder 7.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 52

Possible causes

  • Cylinder 7 control wire shorted to a voltage feed high
  • Low-resistance coil in the cylinder 7 solenoid medium
  • Engine control module driver defective low

Symptoms

  • Check engine lamp on, often only after longer warm drives
  • Cylinder deactivation unavailable

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3452

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication