OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3451

Cylinder 7 Deactivation/Intake Valve Control Circuit Low

P3451 means the switched ground line of the cylinder 7 deactivation solenoid has contact with ground somewhere along its way. GM documents the check for the L84 and L86 trucks and the LT4 Corvette (2019): with the driver off, less than 0.5 ohm to ground, 20 hits in 25 samples taken every 250 ms, Type B, meaning the warning lamp waits for a second faulty trip. According to GM, certain controllers log the open-circuit code P3449 along with it, so both codes together need not mean two faults. On the L84 the high-side feed of the same solenoid reports a ground short under its own code P3117. P3452 is the short to power on this channel, P3450 the mechanical fault.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 51

Possible causes

  • Cylinder 7 control wire pinched or chafed to ground high
  • Cylinder 7 solenoid shorted internally medium
  • Oil or water inside the solenoid connector low
  • Defective driver in the engine control module low

Symptoms

  • Check engine lamp on after two trips
  • P3449 may be stored as well
  • No four-cylinder mode, higher fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3451

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication