OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic or reserved

P3443

Cylinder 6 Deactivation/Intake Valve Control Circuit Low

Here the engine computer has found the cylinder 6 solenoid's switched lead pulled to ground. GM spells out the test for its 2019 V8s (L84, L86 and the LT4 Corvette): while the low-side driver is off, an impedance under 0.5 ohm toward ground is a fault, and 20 hits among 25 checks while the powertrain relay supplies at least 11 V store a Type B code. GM adds that some controllers record the open-circuit code P3441 at the same moment, so the pair does not prove two separate faults. On the L84 each solenoid also has a high-side feed, and a short to ground there carries GM's own code P3114. P3444 is the short to voltage on this channel. Cylinder deactivation stays off until the fault is repaired.

SystemPowertrain
Typegeneric or reserved
GroupP3
Range / number4 / 43

Possible causes

  • Insulation of the cylinder 6 control wire worn through to ground high
  • Cylinder 6 solenoid shorted internally to its housing medium
  • Moisture or oil bridging the pins of the solenoid connector low
  • Output stage in the engine control module damaged low

Symptoms

  • Check engine lamp on from the second faulty trip
  • Four-cylinder mode no longer available
  • P3441 stored at the same time on some GM controllers

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P3443

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication