P3436
Cylinder 5 Deactivation/Intake Valve Control Circuit High
P3436 is the short-to-power code for the cylinder 5 deactivation valve. Publicly it is documented by GM for the L84 V8 (2019), where Dynamic Fuel Management uses a dedicated valve lifter oil solenoid for each of the eight cylinders. The engine computer checks the line while its low-side driver is on; an impedance below 0.5 ohm toward supply voltage counts as a fault, confirmed by 20 of 25 samples at 250 ms, with at least 11 V and 425 rpm. As a Type B code it lights the lamp after two consecutive trips. Because the solenoid then cannot be switched in a controlled way, cylinder 5 is excluded from deactivation. Siblings: P3433 open, P3435 short to ground, P3434 function.
Possible causes
- Control wire touching a voltage supply high
- Shorted coil in the cylinder 5 solenoid medium
- Engine control module output stage defect low
Symptoms
- Check engine lamp after two trips
- Dynamic Fuel Management disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3436
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.