P3428
Cylinder 4 Deactivation/Intake Valve Control Circuit High
P3428 means the wire that switches cylinder 4's deactivation solenoid is tied to voltage. GM's bulletin 20-NA-038 lists cylinders 1, 4, 6 and 7 as the ones its AFM V8s switch to V4 mode, which makes cylinder 4 a standard candidate. In the 2019 documents for L84, L86 and the Corvette LT4, GM judges the circuit with the low-side stage switched on: a supply path of less than half an ohm counts as a short, and 20 bad results within 25 produce a Type B entry and the lamp after two trips. Because the low-side stage sinks the current, a line stuck at battery voltage can push the output into overcurrent, so after repair the module should be checked too. P3427 is the short to ground, P3425 the open. The truck or car keeps all cylinders running.
Possible causes
- Cylinder 4 control wire shorted to a 12 V feed high
- Low-resistance winding in the cylinder 4 solenoid medium
- Overloaded output stage in the engine control module low
Symptoms
- Check engine lamp on
- No V4 or reduced-cylinder operation
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P3428
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.